Torch on off
-
- 1.5 Star Member
- Posts: 37
- Joined: Sun Jul 14, 2013 1:08 pm
Torch on off
I was cutting some test on some holes today and on the first hole after it cut the torch went off then on the 2nd it cut and stoped at the end of the cut and never went off then moved to next one still on, what control this
4x8 Precison plasma table
Candcnc
Sheetcam,Mach3
TD cutmaster 82
Candcnc
Sheetcam,Mach3
TD cutmaster 82
-
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Torch on off
Your machine g code file controls plasma start and stop. You will have to look at it to detrmine what went wrong.
jim Colt
jim Colt
Little Leonard wrote:I was cutting some test on some holes today and on the first hole after it cut the torch went off then on the 2nd it cut and stoped at the end of the cut and never went off then moved to next one still on, what control this