Hello all,
My new Torchmate X came in. We have everything set and are ready to run a line test. I can run the line test through without the torch on with no problems. When we turn the plasma on and try to run the test we get a fault (pierce signal not received). I am new to cnc and Torchmate is closed for the long weekend. I went back and checked everything I could think of. If anyone could help I would certainly appreciate it. I was really looking forward to running this weekend. Plasma is a HT 85 connected with 240 single phase. I'm certain the main power to the machine is correct, just doesn't seem to be communicating with TM correctly.
Need some guidance - Torchmate X
-
- 1.5 Star Member
- Posts: 41
- Joined: Wed Aug 22, 2012 12:37 am
- Location: Texas
-
- 1.5 Star Member
- Posts: 41
- Joined: Wed Aug 22, 2012 12:37 am
- Location: Texas
Re: Need some guidance
Well I figured it out. I hate doing stupid things. Turns out that the consumables weren't tightened correctly. You live you learn I suppose.
-
- 1 Star Member
- Posts: 13
- Joined: Fri Aug 10, 2012 1:26 pm
Re: Need some guidance - Torchmate X
what has your experince with this table been? I am looking to purchase a 5x10 this year.