In need of a fanned out turkey tail

GWS.Arkansas · Post by **GWS.Arkansas** » Fri Oct 26, 2012 4:24 pm

I am needing a turkey tail that is fanned out. I found a few turkey on here but would like just the fanned tail. Any help would be great. Thanks

Post by **DARRYL21270** » Fri Oct 26, 2012 5:33 pm

Here's one

Weldtutor · Post by **Weldtutor** » Fri Oct 26, 2012 7:51 pm

The attached DXF has separate fanned tail & body section that can be used to assemble the turkey shown in the photo.

Together they make an interesting decoration for the Thanksgiving season.

Taken apart, they are flat for storage.

Buzzard Gut · Post by **Buzzard Gut** » Fri Oct 26, 2012 10:09 pm

DARRY21270 Your to much.....

GWS.Arkansas · Post by **GWS.Arkansas** » Fri Oct 26, 2012 10:26 pm

that is neat looking the wife is wanting me to cut one of those for the kitchen table. thanks for that one . but not really what i was needing Would like a fairly detailed turkey tail fanned out so that I can put in an oval with the guys name around it. Anyone have something like that.. Thanks for the help

metalart · Post by **metalart** » Sat Oct 27, 2012 11:10 am

Not sure if this is what you're looking for, hope it helps.

GWS.Arkansas · Post by **GWS.Arkansas** » Sun Oct 28, 2012 1:48 pm

Yes that will be perfect. Thanks to all of you for your help with this.

Post by **ctorres3120** » Sun Oct 28, 2012 2:21 pm

This tail is 3D turkeys, I hope it works for you.
Carlos

In need of a fanned out turkey tail

In need of a fanned out turkey tail

Re: In need of a fanned out turkey tail

Re: In need of a fanned out turkey tail

Re: In need of a fanned out turkey tail

Re: In need of a fanned out turkey tail

Re: In need of a fanned out turkey tail

Re: In need of a fanned out turkey tail

Re: In need of a fanned out turkey tail