New growth 2x4 table issues,....need help !
-
- 2 Star Member
- Posts: 51
- Joined: Tue Sep 08, 2015 12:09 am
New growth 2x4 table issues,....need help !
Having issues cutting on my new growth water table. Using accumove 2 controller and hypertherm65. When in dry run mode it travels fine. But in active run, it just pierces a hole and shuts down after 5 seconds or so. I'm also not sure I have my hypertherm65 set up correctly. any help is greatly appricated. Trying to cut 16 gauge.
-
- 1/2 Star Member
- Posts: 4
- Joined: Sat Oct 18, 2014 7:00 pm
Re: New growth 2x4 table issues,....need help !
do you have the raw arc voltage wire hooked up? along with the ok to move? sometimes when i forget to hook my ground to the metal it will do that maybe your not getting a good ground? in dry mode it dont look for those signals so it will just run
-
- 2 Star Member
- Posts: 51
- Joined: Tue Sep 08, 2015 12:09 am
Re: New growth 2x4 table issues,....need help !
Thanks, It was a bad ground in my electrical panel.