It is currently Tue Sep 25, 2018 3:22 pm

 

Can somebody give me dimension on a Dynatorch table?

Dynatorch hardware discussion forum
calsdad
Posts: 30
Joined: Tue May 06, 2014 11:51 pm

Can somebody give me dimension on a Dynatorch table?

Postby calsdad » Sat Jun 16, 2018 9:39 am

I bought a used Dynatorch XLR8 4x4 table - and I'm going to be heading out to pick the thing up tomorrow.

I would like to put the Gantry assembly into the back of my truck - but I'm not sure if it's going to fit.

So what I'm wondering is - if somebody has an XLR, XLS, or XLE system - if they could take a measurement
of the * total * length of the gantry and give me some numbers. What I'm looking for is the length of the gantry
- outside edge to outside edge.

If you don't have a 4ft wide table but have a 5ft or other width table - telling me the width of your table and
then the length of the gantry would also be really helpful. I could figure out the length of the gantry on the
4ft wide machine from there.

A total height measurement would be greatly appreciated too.



I tried to get this information out of Dynatorch and from the seller of the machine - and they've all been less than helpful.

Thanks!!

tcaudle
Posts: 1025
Joined: Tue Feb 28, 2012 6:47 pm

Re: Can somebody give me dimension on a Dynatorch table?

Postby tcaudle » Sat Jun 16, 2018 6:16 pm

Better hope it runs and cuts. Based on not even being able to get dimensions, getting support might be an issue.

Dawgonhawg
Posts: 483
Joined: Sun Mar 27, 2011 10:13 pm

Re: Can somebody give me dimension on a Dynatorch table?

Postby Dawgonhawg » Sun Jun 17, 2018 12:02 am

Hard to believe Dynatorch tech support will not help you. Have always got great support from there. If fact just got my second Dynatorch about 2 months ago. Ask for Russell or Mike...they will help you.


Return to “Dynatorch”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's