It is currently Wed Aug 15, 2018 5:47 am
Dynatorch hardware discussion forum
1 post • Page 1 of 1
- Posts: 1
- Joined: Fri Sep 23, 2016 7:51 pm
I'm trying to make my first cut but am getting this message. For whatever reason my thermal dynamics A80 isn't connecting to the table. I have the box checked for "Automatically connect at startup" but it doesn't connect and when I try to test the ports it gives the message: "This manufacturer is not currently supported." even though TD is one of the manufacturers you can select.
Who is online
Users browsing this forum: No registered users and 1 guest