Page 1 of 1

Need Help Please

Posted: Fri Sep 08, 2017 11:24 pm
by goldwinger
Need to convert this into a DXF file approx. 12.5" x 12.5"
any help would appreciated
vader mess logo.JPG

Re: Need Help Please

Posted: Wed Sep 13, 2017 8:49 am
by Cz_apie
Try this one

Vader Chief Mess Fixed.JPG


Vader chief.rar



Thanks
Deon

Re: Need Help Please

Posted: Sun Sep 17, 2017 2:01 pm
by goldwinger
Deon
Thank you very much for your help, I will try cutting this out today my fingers are crossed
I will message you and let you know it WORKED GREAT, as i'm sure it will

Thanks again
Ken S.

Re: Need Help Please

Posted: Sun Sep 17, 2017 6:57 pm
by goldwinger
Deon
Thanks for trying but it didn't cut well at all
Would be easier if client could accept larger size, but won't

thanks

Re: Need Help Please

Posted: Sun Sep 17, 2017 10:41 pm
by rdj357
Here you go, hope this helps. It is far from perfect but should cut. Took me a little over an hour to do - original art was poor resolution and the thing needs a ton of bridging to cut without fallouts and spindly messes. I might have missed some but it's bedtime and tomorrow is a short vacay!

Good luck!

Mess.png

Re: Need Help Please

Posted: Fri Sep 29, 2017 11:09 pm
by goldwinger
rdj357
I want to Thank you for the help that you did with this piece.
I'm new at this but hope to be able to learn some of the tricks of the trade. (I hope soon)
Again Thank You so much for your help, you don't know how much I appreciate what you did for me.

Goldwinger
Ken S.

Re: Need Help Please

Posted: Sat Sep 30, 2017 7:20 am
by rdj357
No problem Ken, hope it helps to see kind of how the process goes for editing and bridging and will get you started in the right direction!