It is currently Tue Aug 21, 2018 8:34 am

 

Arclight Dynamics CNC controller stuck in "hold" advice ?

Arclight Hardware discussion forum.
Stickman
Posts: 1
Joined: Sun Feb 25, 2018 2:31 pm

Arclight Dynamics CNC controller stuck in "hold" advice ?

Postby Stickman » Mon Apr 09, 2018 1:11 am

I have a ArcLight Dynamics 5X5 Table and have been very happy until today. Powered it up and the CNC controller is stuck in "hold" even when powered up with all motors and inputs disconnected. Has anyone encountered this and have a few troubleshooting tips? The CNC controller works with Command CNC.

Appreciate all that may help.

BanksAg
Elite Contributing Member
Elite Contributing Member
Posts: 136
Joined: Fri Nov 18, 2016 5:13 pm

Re: Arclight Dynamics CNC controller stuck in "hold" advice ?

Postby BanksAg » Tue Apr 10, 2018 2:47 pm

I haven't run into that problem, but if you haven't already figured it out, give them a call. Their tech support is awesome!
Tim Eggleston
Banks High School
Banks, OR

Arc Pro 4800
PowerMax 45XP
Mach 3, SheetCam
Inkscape, Rhino 3D

tcaudle
Posts: 1011
Joined: Tue Feb 28, 2012 6:47 pm

Re: Arclight Dynamics CNC controller stuck in "hold" advice ?

Postby tcaudle » Tue Apr 10, 2018 7:42 pm

Motion hold? As in the HOLD LED is on on the DTHC Module? (red LED) Of you cannot get it to power up the motors (power supply fault?)


Return to “Arclight Dynamics”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's