Hey there Spider group and Arclight lovers,
We are coming up on our 1 year anniversary with our beloved 4800. We have been busier than expected and times had really flown.
Table has realy out preformed our expectations. Seems just like yesterday we were in Bend receiving training.
Can say enough about Arclight. We tell everyone who listens about our experience...
In fact, my favorite component is the tube cutting axis and we have been so busy it has not spun a tube yet. That is the shame of it all.
It is currently Thu Jul 19, 2018 11:42 am
Arclight Hardware discussion forum.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests