Won't fire up

Arclight Hardware discussion forum.
Post Reply
seajinx
3 Star Member
3 Star Member
Posts: 311
Joined: Fri Oct 31, 2014 8:50 am
Location: East Tennessee

Won't fire up

Post by seajinx »

Ok, Connected all the X,Y,Z and A wires to my ArcLight 12000. Brought my file in to Mach 3 Hit run and Zilch, nothing, Nada. The gantry moved to the start point, touched the plate, came up and stopped there. Not even a hint of spark from the HT 85. I'm cutting 12 gauge steel, tip is 85 amp and the HT 85 is set to 85 amp output. I'm assuming you set the Amps on the Torch acording to the amperage your tip is set for or is my thinking wrong. And can someone tell me where the PMW network wire connects to?
seajinx
3 Star Member
3 Star Member
Posts: 311
Joined: Fri Oct 31, 2014 8:50 am
Location: East Tennessee

Re: Won't fire up

Post by seajinx »

Cancel the PMW connection. Found it went to the HT 85 sensor. Is the voltage to torch suppose to be a constant reading or is it erratic until it makes an arc? This is a big learning curve for me and in need of help. Thank you.
seajinx
3 Star Member
3 Star Member
Posts: 311
Joined: Fri Oct 31, 2014 8:50 am
Location: East Tennessee

Re: Won't fire up

Post by seajinx »

After a thorough brain racking and frustrating moments. I've located the culprit of why it wouldn't fire up. Apparently my wiring in the plug o he plasma cutter didn't have proper contact. System is up and running, but ran into a snag with the THC tip Volts outside fault range. found my answer in the PS search. Was a simple jack up the Air pressure and problem solved. Thanks PS for a great web site.
User avatar
WyoGreen
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 897
Joined: Tue Mar 04, 2014 8:36 pm
Location: Cheyenne, Wyoming

Re: Won't fire up

Post by WyoGreen »

I'm glad we were able to help! :lol:
Precision Plasma gantry
CommandCNC Linux controller w/Feather Touch & PN200 hand controller
HT-45 plasma cutter
Plate Marker
Router
Laser
drossmaker
2.5 Star Member
2.5 Star Member
Posts: 101
Joined: Tue Oct 12, 2010 2:36 am
Location: Bend, Oregon
Contact:

Re: Won't fire up

Post by drossmaker »

seajunx,
We are glad to hear your table is up and running. If you ever have issue or questions about your table give us a call for a faster response: 866-222-2154. We check PlasmaSpider M-W-F.

-drossmaker
drossmaker
2.5 Star Member
2.5 Star Member
Posts: 101
Joined: Tue Oct 12, 2010 2:36 am
Location: Bend, Oregon
Contact:

Re: Won't fire up

Post by drossmaker »

seajinx,
glad we were able to get you back up and running.

-drossmaker
Post Reply

Return to “Arclight Dynamics”