The new plasma marking system is here. This system includes a brand new Hypertherm Powermax 45 XP. The new XP is capable of marking by running very low currents as low as 10A. Typical marking is done at between 10A and 15A. A machine set up with plasma marking will have two torches, as shown in the photo below. The torch to the right is mounted on an air lifter and is dedicated to marking using Argon gas. When the marking process is selected, the marking torch is lowered into place using the air lifter.
New Powermax 45XP
New 180* Machine Torch
Starter set of consumables for marking
Torch mount assembly for marking
Available for SeriesOne, XT, XT-P and Pro machines.
https://www.youtube.com/watch?v=MOxWSpK ... e=youtu.be
It is currently Thu Oct 19, 2017 3:49 pm
Trucut CNC Hardware discussion forum
1 post • Page 1 of 1
Users browsing this forum: No registered users and 1 guest