Hello
I have a problem with my hypertherm 130 . Specially when I use a 130 oxygen/air. And the error message code 20 appears. " Lose arc pilote". But when I create a leak in the oxygen plasma it works. Can anyone explain how to resolve this problem.
Thank you
Problem with hypertherm hsd 130
-
- 1/2 Star Member
- Posts: 1
- Joined: Sun Apr 22, 2018 7:58 am
-
- 3 Star Elite Contributing Member
- Posts: 445
- Joined: Sat Jul 04, 2015 10:43 pm
Re: Problem with hypertherm hsd 130
I would repost this up the the plasma cutter (Hypertherm) section for Jim Colt to reply.
Steve
Platform CNC Plasma table
CandCNC Ethercut IV DTHC
Hypertherm 85/CPC/RS485
Miller 350P
Miller Dynasty 280DX
Platform CNC Plasma table
CandCNC Ethercut IV DTHC
Hypertherm 85/CPC/RS485
Miller 350P
Miller Dynasty 280DX
-
- 1 Star Member
- Posts: 23
- Joined: Fri Dec 01, 2017 3:44 pm
- Location: Nashville, Arkansas
Re: Problem with hypertherm hsd 130
I have heard of people having similar problems in the past when the pressure was too high going into the auto gas control unit. Check and see what your pressure regulator on your oxygen is set at and try to adjust it down and see if that helps.