Page 1 of 1

Mach3 Button for Feedhold / Pause after the current cut

Posted: Tue Dec 12, 2017 4:23 am
by East German
Hello,

Mach 3 Button for Feedhold / Pause after the current cut.

Make a LED and a Button on / off on the Screen here User LED 1322:

If(GetUserLED (1322)=1) Then
SetUserLED(1322,0)
Else
SetUserLED(1322,1)
end if

In the Macro M 5 this:

If (GetUserLED(1322)=1)Then
DoOemButton(1001)
End If

If the LED is turned on during the cut Mach3 pauses after the cut.
Is the LED on power press the Start Button Mach 3 only makes a cut.

Peter