It is currently Wed Dec 13, 2017 9:54 am

 

Indoor and Outdoor Sign standoff discussion thread

Share tips and tricks you know of in this forum. Plasma cutting, material handling, metal finishing, marketing, or anything that you feel is helpful.
User avatar
Nacs Fab
Posts: 268
Joined: Tue Dec 04, 2012 4:11 pm
Location: Columbia, MO

Indoor and Outdoor Sign standoff discussion thread

Postby Nacs Fab » Wed Aug 09, 2017 11:50 am

I have made a few signs with individual letters for outdoor installation in stucco siding and wonder about installing a sign in sheet rock. Could I use the same principal or do you have any good ideas for attaching small individual letters to a sheet rock surface? I would rather do the pegs like I did on the sign below. Basically I welded 1/4" metal dowels to the back of the sign - 3" long and printed a full size template for general contractor to tape up and drill the holes to install it. They then used a quick set epoxy in the holes and positioned the letters.

Sign Crop.jpg


20604733_500863033586446_6843520270195393183_n.jpg


Give me some ideas you have used to install a standoff sign in sheet rock. Thanks!

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here

Shop Droids Plasmabot 3.0 DIY 4x8 with water table
G540 with LCTHC by candcnc
Hypertherm 1250 with Duramax Torch Upgrade
all built... by me...

Return to “Tech Tips”

Who is online

Users browsing this forum: No registered users and 2 guests