Table slide

Share and learn with other DIY members who have built their own plasma tables and accessories.
Post Reply
jim fry
1/2 Star Member
1/2 Star Member
Posts: 8
Joined: Sun Jul 19, 2009 3:49 pm
Location: Tempe,az
Contact:

Table slide

Post by jim fry »

So I went in and build a parts slide into my table. It works great when little parts fall thru the table they slide down to the bottom. So I just lift the door and there right there. Even if it is just drop and metal dust. A lot of that slides down to the bottom so that help me keep my table nice and clean. When I design the slide I to added step to putting a big vacuum on the table to suck the dust out. That will be next month. So we will have to wait and see if that works good. :D
fab-man
1.5 Star Member
1.5 Star Member
Posts: 35
Joined: Fri Apr 17, 2009 11:53 am

Re: Plasma Table Parts Slide

Post by fab-man »

Nice job Jim, I hate sifting through my scrap heap to find a part I just cut!!! :x

fab-man
jim fry
1/2 Star Member
1/2 Star Member
Posts: 8
Joined: Sun Jul 19, 2009 3:49 pm
Location: Tempe,az
Contact:

Re: Table slide

Post by jim fry »

Yea I i hated trying to reach my arm to get hot part. I hope to get a down draft set up in it soon
ce offroad
1 Star Member
1 Star Member
Posts: 18
Joined: Wed Jun 24, 2009 5:29 pm

Re: Table slide

Post by ce offroad »

how is this working out so far? I have this in my plans...
Post Reply

Return to “DIY Plasma Table & Accessory Discussion Forum”