Page 1 of 1

Name for this part? Arc Shield?

Posted: Thu Nov 16, 2017 4:38 am
by mrjackg
Hello, I am new to this forum.

Just asking for some guidance on the name of the part or whether people just make these themselves? I am talking about the shield placed onto the cutting torch to shield the arc light from the operator. Is there a specific name for this and can you buy these as a part generally?

Capture.PNG

Re: Name for this part? Arc Shield?

Posted: Thu Nov 16, 2017 7:33 pm
by little blue choo
Tried this and it didn't work very well. Was always catching tip ups and ruining my art work. Might work good with long straight cuts but didn't work with artwork.

Rick