It is currently Fri Feb 23, 2018 1:44 pm
This forum is for plasma cutting related tools and accessories. Discuss products and tools that have worked or not worked for you.
1 post • Page 1 of 1
- Posts: 146
- Joined: Tue Aug 18, 2015 11:30 am
I am installing a Proma 150 THC to a Gecko G540 and a Miller Spectrum 875 plasma machine. I would like a wiring diagram for the setup. I am to the point that I need to connect the machine torch cutting tip to a point in the wiring system or does it get connected to a grounding point on the table.
Who is online
Users browsing this forum: No registered users and 2 guests