6'' Velox z axis side plates

[SeanP]

I made these up as I was noticing a bit of flex in the back plate of the z axis, adding these cured that all together.

You might notice I have fitted a extra linear bearing on the lower part, I was just starting to feel a little play in the original so squeezed another bearing on either side, it's been like that for 12 months now, just oil and clean fairly often.
It was just a cheapo chinese bearing I had, don't think it's any different quality to what velux supplied.

Link here to diy breakaway mount fitted also

P1030374.JPG

Z axis side supports.DXF

[Capstone]

Thanks Sean