It is currently Fri Nov 24, 2017 12:53 am

 

Metal cleaning

Learn and share dross removal techniques, experiences, and product knowledge here.
exceptional
Posts: 65
Joined: Tue Jun 24, 2014 10:24 pm

Metal cleaning

Postby exceptional » Thu Jun 26, 2014 8:55 pm

I have watched videos, but when I powder coated my piece, it has some flaws. I'm still not sure about the clean up of metal to prepare it for patina or powder coating finishes. Is dipping it in acid enough, or do I need to pull it out and sand it down with 120 grit? looking for that flawless metal to finish up. Getting into patinas in about a week and would like to have my foundations sets before running into problems. Thanks for your time.

User avatar
tnbndr
Elite Contributing Member
Elite Contributing Member
Posts: 1354
Joined: Mon Jan 09, 2012 4:30 pm
Location: New Berlin, WI
Contact:

Re: Metal cleaning

Postby tnbndr » Fri Jun 27, 2014 10:25 am

Watch the videos on Steel FX site for clean up. Basically after acid dipping to get rid of mill scale you need to grind with 120 grit disc to get shiny metal for patinas.
As for powder coating, it won't hide defects so I would at minimum do the same prep.
Dennis
LDR 4x8, Scribe, DTHCIV
PM45
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
[email protected], [email protected]
Miller 211
RW 390E Slip Roll
AutoCAD, SheetCAM, Mach 3
https://www.facebook.com/ikescreations?ref=hl
http://ikescreations.com

exceptional
Posts: 65
Joined: Tue Jun 24, 2014 10:24 pm

Re: Metal cleaning

Postby exceptional » Fri Jun 27, 2014 11:46 am

Perfect, thank you.

bndave
Posts: 2
Joined: Sun Jul 13, 2014 6:10 pm
Location: Utah

Re: Metal cleaning

Postby bndave » Wed Dec 24, 2014 5:26 pm

i find that sanding and sometimes buffing will clean up the steel for powder coat well

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here


User avatar
AnotherDano
Elite Contributing Member
Elite Contributing Member
Posts: 816
Joined: Fri Dec 18, 2009 11:52 pm
Location: Laramie, Wyoming
Contact:

Re: Metal cleaning

Postby AnotherDano » Wed Dec 24, 2014 6:20 pm

I use a belt sander with 50 grit to provide lots of 'tooth'.

Then using a pressurized sprayer, the piece is drenched with alcohol (very fine spray) until there are no 'breaks'.
Using a clean 3" paintbrush, remaining alcohol is brushed away and the piece is torched to remove any fuzzies.

Then I coat it.

Dano
Dano Roberts
[email protected]
PlasmaCam DHC-2 v3.11
Hypertherm PowerMax-30
Serving Laramie, Wy since Thursday


Return to “Dross/Slag Removal”

Who is online

Users browsing this forum: No registered users and 1 guest