Torch coloring stainless steel

Learn and share top coat finishing techniques, experiences, and product knowledge here. Paint, anodize, rubber coating, etc.
Post Reply
Cracker Red
2.5 Star Member
2.5 Star Member
Posts: 155
Joined: Sat May 03, 2014 3:24 pm

Torch coloring stainless steel

Post by Cracker Red »

I've colored stainless before using a torch. I'm trying to achieve more definition to the areas. Best example I can give is being done by http://metalfish66.com/

Check out the crab....and figure out how that is being done?!? My best guess is it is 2 layers? How are the heat zones so well defined when the piece of stainless "soaks" up the heat
User avatar
little blue choo
4 Star Member
4 Star Member
Posts: 1460
Joined: Mon Mar 02, 2015 10:38 pm
Location: Cherryville NC
Contact:

Re: Torch coloring stainless steel

Post by little blue choo »

The crab looks awesome but I don't believe it was done with a torch. Looks more like dyes or candy paints to me.

Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
muzza
4 Star Member
4 Star Member
Posts: 1472
Joined: Wed Feb 04, 2009 5:35 pm

Re: Torch coloring stainless steel

Post by muzza »

Quote direct from his website
" The array of colors is achieved by controlled heat, a process known as fire color. The colors are not painted on, but rather drawn out of the metal by different temperatures of heat."

It takes a bit of practice with the torch to work out flame intensity and when to pull the torch away as it will continue to colour after the torch is removed. Tip size also plays a part to make sure you are heating it quick enough or not too quick so you don't turn the whole piece blue.
Murray
User avatar
little blue choo
4 Star Member
4 Star Member
Posts: 1460
Joined: Mon Mar 02, 2015 10:38 pm
Location: Cherryville NC
Contact:

Re: Torch coloring stainless steel

Post by little blue choo »

I will never believe all those colors and fine lines were done entirely by a torch.

Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
Post Reply

Return to “Paint & Other Top Coats”