I'm working on a piece that is two pieces . The front is steel coper patina . The backer will be attached to front and is stainless . I was gonna tack weld them together . If apply copper fx to the front ,what will it do to the stainless?
Thanks
Copper patina with stainless backer question
-
Sampson Jones
- 3 Star Elite Contributing Member
- Posts: 333
- Joined: Mon Jul 25, 2011 9:30 pm
Copper patina with stainless backer question
My design , 4ft x 8 ft water table
CandCNC electronics
Hypertherm powermax 65
Command Lineux
Super z 2
Sheetcam
Inkscape and corel draw
CandCNC electronics
Hypertherm powermax 65
Command Lineux
Super z 2
Sheetcam
Inkscape and corel draw
-
steelfx
- 4 Star Elite Contributing Member
- Posts: 768
- Joined: Sat Oct 10, 2009 12:09 am
- Location: St. George, Utah
- Contact:
Re: Copper patina with stainless backer question
Most SS alloys are totally unaffected by the COPPER F/X™. I usually get 304 or 316, and they're both "immune" to my patinas. There are other exotic SS alloys that may have enough iron and/or carbon in them, that they might be stained a little.
Hope that helps!
Bill
Hope that helps!
Bill
