It is currently Thu Jul 19, 2018 11:42 am

 

Converting a font into a line instead of block?

Inkscape related questions and tips can be posted to this topic.
Twentysixtimber
Posts: 2
Joined: Tue May 29, 2018 8:15 am

Converting a font into a line instead of block?

Postby Twentysixtimber » Tue May 29, 2018 9:13 am

I am trying to cut out a word and the width of the letters is the same as my kerf. I am trying to make the font so that it is one cut instead of cutting the going around the whole letter twice. Is there away to make a font just a line instead of a block letter. I’m sorry I’m advance if I sound confusing. I’m just learning this all on my own..

plasmanewbie
Elite Contributing Member
Elite Contributing Member
Posts: 336
Joined: Thu Jul 24, 2008 11:15 am

Re: Converting a font into a line instead of block?

Postby plasmanewbie » Tue May 29, 2018 9:26 am

I think you are looking for is called a stick font, or single line font. Check this thread http://www.plasmaspider.com/viewtopic.php?t=15379 and http://www.plasmaspider.com/viewtopic.php?t=10654

Twentysixtimber
Posts: 2
Joined: Tue May 29, 2018 8:15 am

Re: Converting a font into a line instead of block?

Postby Twentysixtimber » Tue May 29, 2018 9:38 am

I think this may help me. I will try it tonight. I use sheetcam and I’m hoping to just set no offset and be ok. Any other tips would be appreciated. Thank you!!


Return to “Inkscape”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's