a80/sl100sv problem

Thermal Dynamics plasma cutter discussion forum.
Post Reply
ob505
1/2 Star Member
1/2 Star Member
Posts: 4
Joined: Thu Nov 25, 2010 5:51 pm
Location: Brandon, FL

a80/sl100sv problem

Post by ob505 »

I have a torchmate 5x10 set up, have been slowly trying to get it up and running, new to all this. I can turn revrything on and it cuts the first sign beatufily, then when I reset everything to cut another just like it on another section of the plate, the thing goes about halfway into the program then ethier freezes or the torch quits cutting. I get a fault light and 85 code flashing on the machine and I have to shut the machine off to reset. Any suggestions out there?......GH
ob505
1/2 Star Member
1/2 Star Member
Posts: 4
Joined: Thu Nov 25, 2010 5:51 pm
Location: Brandon, FL

Re: a80/sl100sv problem

Post by ob505 »

Right now I am losing hope, spent an hour with the torchmate tech guys for the past two nights, still having issues. Going to try and call thermal dyn and see if they can figure out the problem. It gets an ok to move signal only part of the time then the next cut the torch fires and will not move. Turned the enale to move toggle off and it moves and cuts, then every few inchs it stops and says feed hold.
Post Reply

Return to “Thermal Dynamics / Esab Plasma Cutters”