annoying pierce issue

Thermal Dynamics plasma cutter discussion forum.
Post Reply
hacnwac
2.5 Star Member
2.5 Star Member
Posts: 109
Joined: Sun Mar 27, 2011 8:14 pm
Location: on canada

annoying pierce issue

Post by hacnwac »

I have a cutmaster 101 and it has inconsistant piercing issues. It may pierce properly from 1 to 20 times in a row and then not pierce right for the same amount and then good again. The air is clean and dry. It seems as if when it doesn't pierce quite right it is not getting full power. Even after a bad pierce after the pierce delay is done it cuts just fine when it starts on cut path. The longer the lead in the better with this problem. It seems like this problem is progressively getting worse. I know this is an older machine but the cuts are good its just the pierce issue that stinks. The 101 is on a Tracker 5 x 10 table heavily modified. Any suggestions.
Thanks Mark
mike 1948
2 Star Member
2 Star Member
Posts: 66
Joined: Wed May 08, 2013 11:23 am

Re: annoying pierce issue

Post by mike 1948 »

I had something similar awhile back. I found out after taking it in for repairs that I had not seated the torch plug completely into the socket. The rim of the plug was about 1/8 of a inch from being seated to the shoulder. Properly seated it was about 1/32 away from the shoulder.

Mike
Post Reply

Return to “Thermal Dynamics / Esab Plasma Cutters”