It is currently Thu Sep 20, 2018 7:05 am

 

burntables w/ thermal dynamics plasma help

Thermal Dynamics plasma cutter discussion forum.
Coffinscreekcustoms
Posts: 114
Joined: Mon Apr 23, 2012 10:44 pm
Location: Masonville IA
Contact:

burntables w/ thermal dynamics plasma help

Postby Coffinscreekcustoms » Fri Dec 27, 2013 6:43 pm

Hello y'all I just got my box back from getting serviced and like a [email protected]$$ I didn't mark my wires to get hooked back up! So questions are the two wires coming out of my torch box one is connected to the positive lead and one to the ground
So would the one connected to the positive be torch - and the one from the ground be connected to table +? Really appreciate any help I can't get ahold of kyle or matt ...
Thanks jake

jimcolt
Elite Contributing Member
Elite Contributing Member
Posts: 2929
Joined: Mon Jul 20, 2009 11:18 pm
Location: New Hampshire

Re: burntables w/ thermal dynamics plasma help

Postby jimcolt » Fri Dec 27, 2013 6:46 pm

The work ground clamp on all plasma cutters is + (positive), the electrode in the torch is always - 9 (negative).

Jim Colt Hypertherm


Coffinscreekcustoms wrote:Hello y'all I just got my box back from getting serviced and like a [email protected]$$ I didn't mark my wires to get hooked back up! So questions are the two wires coming out of my torch box one is connected to the positive lead and one to the ground
So would the one connected to the positive be torch - and the one from the ground be connected to table +? Really appreciate any help I can't get ahold of kyle or matt ...
Thanks jake


Return to “Thermal Dynamics Plasma Cutters”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's