It is currently Mon Sep 24, 2018 11:26 pm

 

26 gauge sheet

Thermal Dynamics plasma cutter discussion forum.
dharms
Posts: 38
Joined: Wed Mar 14, 2012 2:56 pm

26 gauge sheet

Postby dharms » Mon Sep 16, 2013 4:59 pm

Hi All,

Say has anyone cut 26 ga. sheet? I have a Thermal Dynamics A120 and Torchmate 2 and was hoping someone might have the settings that would work. I also have AVHC.

Any help would be appreciated.

Thanks in Advance.

User avatar
mlinehan
Posts: 29
Joined: Tue Apr 23, 2013 8:48 am

Re: 26 gauge sheet

Postby mlinehan » Tue Sep 17, 2013 9:39 am

Use 40A, 180 ipm, 0.14 cut height

gary42095
Elite Contributing Member
Elite Contributing Member
Posts: 194
Joined: Sun Feb 26, 2012 1:42 pm

Re: 26 gauge sheet

Postby gary42095 » Mon Nov 18, 2013 5:26 pm

180ipm seems aweful slow to me on 26 ga not sure about td cut settings but i know hypertherm is up around 400ipm down to 25 amps. your going to want 0s pierce delay as well. i just cut 22ga on a powermax 85 and had some tuning trouble using mach/sheetcam until i found a box in settings to use mach delay. that cleared it up for me. my speed was [email protected] amps

danny
Posts: 53
Joined: Sun Jun 24, 2012 5:39 pm

Re: 26 gauge sheet

Postby danny » Sat Dec 07, 2013 2:54 pm

gary42095 wrote:180ipm seems aweful slow to me on 26 ga not sure about td cut settings but i know hypertherm is up around 400ipm down to 25 amps. your going to want 0s pierce delay as well. i just cut 22ga on a powermax 85 and had some tuning trouble using mach/sheetcam until i found a box in settings to use mach delay. that cleared it up for me. my speed was [email protected] amps



Hi Gary,
Just wondering where the box you mentioned is and if it would lower the pierce delay

Thanks, Danny
2X2 Shop built table,proma thc,TB6560 bob
TD cut master 52,SL 100 machine torch
mach3, sheetcam, 26cfm compressor, Ref.air dryer, water seperator, motorguard toilet paper filter


Return to “Thermal Dynamics Plasma Cutters”

Who is online

Users browsing this forum: No registered users and 2 guests

Easyscriber engrave attachment for Hypertherm torch's