Machmotion

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
BensPlasmaAu
2.5 Star Member
2.5 Star Member
Posts: 209
Joined: Mon Jan 13, 2014 10:37 am
Location: Boronia, Melbourne, Australia

Machmotion

Post by BensPlasmaAu »

I was wondering if anyone knew anything about a Machmotion x15-250 controller. See photos below. Any good? What are they worth? Does anyone need on at the moment. I have found one at a very random location that is for sale. I'm still not sure if it is complete, but the control computer and cabinet is all there. Pretty sure there are no motors and not sure if the white control/power supply box is complete still.
machmotion.jpg
machmotion2.jpg
machmotion3.jpg

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

Home built 3400 x 1400mm (11 and a bit X a bit over 4.5 feet)
Hypertherm Powermax 45
CandCNC Bladerunner IV
Some air dryer off the internet
Another water seperator I found unused on a shelf
Refrigerated air dryer
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1352
Joined: Tue Feb 28, 2012 6:47 pm

Re: Machmotion

Post by tcaudle »

That may or may not have a parallel port interface to the PC (most likely it does) . The THC is either a THC300 (no presets ) or a later THC301D. Both are obsolete and you cannot get parts or support. It may have drivers internally and it will probably be steppers. They advertise life time tech support so they should be able to give you some help if you end up buying it.
Post Reply

Return to “Various Manufacturers Forum”