ETHERNET Smoothstepper
-
seajinx
- 3 Star Member
- Posts: 311
- Joined: Fri Oct 31, 2014 8:50 am
- Location: East Tennessee
ETHERNET Smoothstepper
Can someone explain, Ethernet Smoothstepper running out of Data and how to resolved the issue, This happens very time i tend to cut files That have a lot of Pierces. I'm having to go back and rearrange the file to remove the section it's already cut This is the error message I get.
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
-
comeoutswingin
- 2.5 Star Elite Contributing Member
- Posts: 130
- Joined: Fri Oct 16, 2009 10:34 pm
Re: ETHERNET Smoothstepper
I get this ALOT. Super annoying, but I have found if I dont jog the Z down to about 1" or so above the plate before I restart I get this error.
5x10 LDR
-
tcaudle
- 4 Star Elite Contributing Member
- Posts: 1363
- Joined: Tue Feb 28, 2012 6:47 pm
Re: ETHERNET Smoothstepper
1. PC too slow
2. Increase the buffer size in the Smoothstepper Config
3. There is a bug in MACH3 that can contribute to this.
The ESS has a defined buffer size you can change . It buffers up moves and then spits out the steps about a second or less later. If more data comes in tahn can be turned into motion it overflows and that causes the error.
2. Increase the buffer size in the Smoothstepper Config
3. There is a bug in MACH3 that can contribute to this.
The ESS has a defined buffer size you can change . It buffers up moves and then spits out the steps about a second or less later. If more data comes in tahn can be turned into motion it overflows and that causes the error.
