It is currently Sun Jun 17, 2018 6:08 pm

 

NEED HELP ASAP

Tracker Hardware discussion forum
DARRYL21270
Posts: 491
Joined: Fri Jun 05, 2009 7:09 am
Location: New Jersey
Contact:

NEED HELP ASAP

Postby DARRYL21270 » Sat Nov 05, 2011 4:12 pm

The wires connected to the power button on my Tracker control panel came off and I don't know where they go. Tech support is closed for the weekend, can anybody help.


Thanks

WSS
Posts: 437
Joined: Wed Sep 29, 2010 12:19 am

Re: NEED HELP ASAP

Postby WSS » Sat Nov 05, 2011 8:25 pm

Do you have a digital manual or a place on there site you can go for downloads? I looked at the site but did not see any document or help library/page. Possibly as an owner you might?

IF it is just the power button and is two wires, then they can go to either side, it is just a NO switch tht passes power through it. You can check it with a meter to see if it is in fact a normally open switch. In the off position, no continuity should show, when on it should show a closed circuit.

If none of that applies, leave us some more details of what you see and what possibly happened to cause the problem.

WSS

DARRYL21270
Posts: 491
Joined: Fri Jun 05, 2009 7:09 am
Location: New Jersey
Contact:

Re: NEED HELP ASAP

Postby DARRYL21270 » Sun Nov 06, 2011 8:59 pm

All fixed,
Thanks for the help.

WSS
Posts: 437
Joined: Wed Sep 29, 2010 12:19 am

Re: NEED HELP ASAP

Postby WSS » Mon Nov 07, 2011 2:46 am

Cool! I know the feeling when stuff happens and it's the weekend.

WSS

User avatar
Team Tracker
Posts: 103
Joined: Thu Nov 18, 2010 7:36 pm
Contact:

Re: NEED HELP ASAP

Postby Team Tracker » Thu Nov 17, 2011 3:26 pm

DARRYL21270 wrote:The wires connected to the power button on my Tracker control panel came off and I don't know where they go. Tech support is closed for the weekend, can anybody help.


Thanks


For future reference we offer technical support 24/7....just call the number on the front of your system.

Reid T
Image
1-800-590-7804


Return to “Tracker CNC”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's