Help with upsidedown cutting with Torchmate

[tentonjj]

Helo all, I've been here for a little while and found some useful info on here. I have an issue with our torchmate software. When I load it into Torchmate 3 to cut the steel, it always cuts it upside down on the plasma table leaving large slag on the feature side of the piece. I hate using the grider cause it leaves such deep grooves. If I reverse the drawing the same thing happens. Any advice would be great!!!!

[jim]

For my software i use coral draw and then send it to comand and cut. Both have a tool bar at the top of the screen that says mirror.this will flip your drawing over.
Hope this works Jim(murals in metal)