It is currently Tue Oct 17, 2017 2:27 pm

 

New growth 2x4 table issues,....need help !

Torchmate Hardware discussion forum
poppopsworkshop
Posts: 51
Joined: Tue Sep 08, 2015 12:09 am
Contact:

New growth 2x4 table issues,....need help !

Postby poppopsworkshop » Sat Nov 07, 2015 5:10 pm

Having issues cutting on my new growth water table. Using accumove 2 controller and hypertherm65. When in dry run mode it travels fine. But in active run, it just pierces a hole and shuts down after 5 seconds or so. I'm also not sure I have my hypertherm65 set up correctly. any help is greatly appricated. Trying to cut 16 gauge.

madracing007
Posts: 4
Joined: Sat Oct 18, 2014 7:00 pm
Contact:

Re: New growth 2x4 table issues,....need help !

Postby madracing007 » Thu Dec 31, 2015 1:55 pm

do you have the raw arc voltage wire hooked up? along with the ok to move? sometimes when i forget to hook my ground to the metal it will do that maybe your not getting a good ground? in dry mode it dont look for those signals so it will just run

poppopsworkshop
Posts: 51
Joined: Tue Sep 08, 2015 12:09 am
Contact:

Re: New growth 2x4 table issues,....need help !

Postby poppopsworkshop » Mon Mar 21, 2016 1:09 pm

Thanks, It was a bad ground in my electrical panel.


Return to “Torchmate”

Who is online

Users browsing this forum: No registered users and 1 guest