Samson 5x10 initializing issues

PlasmaCam Hardware discussion forum
Post Reply
riddarunner
1 Star Member
1 Star Member
Posts: 11
Joined: Wed May 29, 2013 9:36 am

Samson 5x10 initializing issues

Post by riddarunner »

The machine worked great a few days ago. After a long cut I sent it to the home position and left it. Today, the dezign edge main window says the torch is disconnected where it would normally show the location of the torch head. When I try to initialize the machine it flashes the tall rectangle window on the left side that has the speed controlled. What I mean by flashes it it only shows up for less than half a second. After I command it to initialize I can freely move the torch around so I know it's no moving every very slow, which has also happened in the past.

Already fixed: tech support called and we figured out through the diagnostic option in the machine tab that I have a faulty stop button. A few technical taps on the stop button unjammed it.
User avatar
SegoMan DeSigns
3.5 Star Elite Contributing Member
3.5 Star Elite Contributing Member
Posts: 822
Joined: Sat Jan 06, 2018 4:45 pm

Re: Samson 5x10 initializing issues

Post by SegoMan DeSigns »

Good deal sounds like good tech support.
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”