Turning a 4x4 into a 4x8

PlasmaCam Hardware discussion forum
Post Reply
Borntofabricate
1.5 Star Member
1.5 Star Member
Posts: 25
Joined: Mon Oct 24, 2011 10:04 am

Turning a 4x4 into a 4x8

Post by Borntofabricate »

I found some old posts, but no directions or pictures. Who has done it?

If I understand correctly to turn a DHC2 into a 4x8 I will need to modify/extend the table, install longer gear racks for both sides, and pay Plasmacam a 1000 bucks (wth!?) ??

Anything else?
User avatar
rdj357
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1157
Joined: Sun Mar 11, 2012 4:40 pm
Location: Tahlequah, OK
Contact:

Re: Turning a 4x4 into a 4x8

Post by rdj357 »

You'll also need to extend the wiring harness or call Plasmacam and get the one for the 5x10. I haven't personally done it but several have. Probably a lot of information could be searched for or asked on the Owner's Community. I think Bill Klemm made a list of what was required in parts and the prices.
Borntofabricate
1.5 Star Member
1.5 Star Member
Posts: 25
Joined: Mon Oct 24, 2011 10:04 am

Re: Turning a 4x4 into a 4x8

Post by Borntofabricate »

Thanks. The harness won't reach even if the mast is in the middle?
User avatar
rdj357
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1157
Joined: Sun Mar 11, 2012 4:40 pm
Location: Tahlequah, OK
Contact:

Re: Turning a 4x4 into a 4x8

Post by rdj357 »

It probably would reach. Again, I haven't done it personally since I already own the 5x10 but if you do a little testing and planning I'm sure it won't be too tough.
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”