Page 1 of 1

Plasmacam Height

Posted: Wed Dec 20, 2017 9:52 pm
by Jspece
What is the physical height to the highest point of the cable holder on a plasma cam? Is there any adjustment to it? Interested in a 4x4 unit but my shop has a low cieling.

Re: Plasmacam Height

Posted: Thu Dec 21, 2017 3:02 pm
by Francisco
About 90" / 2.3 m

There's no adjustment, per se. You could modify the setup to make it a little shorter, I guess, but not much. You may end up with either a) the cables dragging or b) losing some cutting area.

Re: Plasmacam Height

Posted: Thu Dec 21, 2017 3:53 pm
by rdj357
I cut mine off about a foot to allow for clearance to my gantry crane. Works fine.

Re: Plasmacam Height

Posted: Thu Dec 21, 2017 4:51 pm
by Jspece
90" really? I'm 1 inch short lol

Re: Plasmacam Height

Posted: Fri Dec 22, 2017 1:14 am
by Rex
I drilled new holes and drop it 5 inch,
Works fine