Plasmacam Height

PlasmaCam Hardware discussion forum
Post Reply
Jspece
1 Star Member
1 Star Member
Posts: 14
Joined: Thu Nov 16, 2017 3:28 pm

Plasmacam Height

Post by Jspece »

What is the physical height to the highest point of the cable holder on a plasma cam? Is there any adjustment to it? Interested in a 4x4 unit but my shop has a low cieling.
User avatar
Francisco
2.5 Star Elite Contributing Member
2.5 Star Elite Contributing Member
Posts: 177
Joined: Tue Feb 23, 2010 4:17 pm

Re: Plasmacam Height

Post by Francisco »

About 90" / 2.3 m

There's no adjustment, per se. You could modify the setup to make it a little shorter, I guess, but not much. You may end up with either a) the cables dragging or b) losing some cutting area.
User avatar
rdj357
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1157
Joined: Sun Mar 11, 2012 4:40 pm
Location: Tahlequah, OK
Contact:

Re: Plasmacam Height

Post by rdj357 »

I cut mine off about a foot to allow for clearance to my gantry crane. Works fine.
Jspece
1 Star Member
1 Star Member
Posts: 14
Joined: Thu Nov 16, 2017 3:28 pm

Re: Plasmacam Height

Post by Jspece »

90" really? I'm 1 inch short lol
Rex
3 Star Elite Contributing Member
3 Star Elite Contributing Member
Posts: 316
Joined: Sat Oct 08, 2016 12:26 pm

Re: Plasmacam Height

Post by Rex »

I drilled new holes and drop it 5 inch,
Works fine
plasmacam 4x8 with DHC2 with Design Edge
Hypertherm 65
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”