Page 1 of 1

Tech question

Posted: Wed Oct 18, 2017 1:45 am
by MJP
Is this supposed to be connected? Had some strange issues come up and I suspect this maybe the issue, this is the interface cable between the controller and plasma cutter. Thanks

Re: Tech question

Posted: Wed Oct 18, 2017 10:04 am
by jimcolt
Can you be more specific? What plasma cutter make and model, are you using a hand torch or machine torch? What strange issues (error codes, etc?). What model Plasmacam (98-Z, DHC, DHC2, Samson, GoTorch?) What level software?