Plasma cam 4x4 table grates

PlasmaCam Hardware discussion forum
Post Reply
kenny
1 Star Member
1 Star Member
Posts: 12
Joined: Sat Dec 24, 2011 12:01 pm

Plasma cam 4x4 table grates

Post by kenny »

Does anyone have plans cut paths for plasma cams 4x4 table grates.
Thank you
PlasmaMac
2.5 Star Member
2.5 Star Member
Posts: 112
Joined: Mon Nov 10, 2014 10:55 am

Re: Plasma cam 4x4 table grates

Post by PlasmaMac »

You might take a look within plasmacam online owners community. Lots plasmacam owners on there that could help out. You can also easily order a set at the same place from plasmacam.

Good Luck Brother,

JAG
User avatar
tnbndr
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1669
Joined: Mon Jan 09, 2012 4:30 pm
Location: New Berlin, WI
Contact:

Re: Plasma cam 4x4 table grates

Post by tnbndr »

Did you look at the first thread on the Plasma CAM section??

http://plasmaspider.com/viewtopic.php?f=61&t=2272
Dennis
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
Amyfreestone
1 Star Member
1 Star Member
Posts: 17
Joined: Fri Aug 26, 2016 8:31 pm

Re: Plasma cam 4x4 table grates

Post by Amyfreestone »

Grate.zip

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

Ironman
2 Star Member
2 Star Member
Posts: 82
Joined: Fri Jul 24, 2009 12:01 am
Location: Warburg, Alberta

Re: Plasma cam 4x4 table grates

Post by Ironman »

kenny wrote:Does anyone have plans cut paths for plasma cams 4x4 table grates.
Thank you
Here are mine. These are for a grate made of 1.5 x 1/8" flat bar and the center slots for the flat bar are offset an inch to give it a curve. This keeps it snug in the slots, and means if you cross a line you won't burn down the whole length. Also ends most tip ups.

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

Binderman01
2 Star Member
2 Star Member
Posts: 66
Joined: Sat Dec 26, 2015 12:14 pm

Re: Plasma cam 4x4 table grates

Post by Binderman01 »

Im coming to a mental block looking at your drawing Ironman. What are the 4ft. pieces that are sunk down with only 3 slots for? got a picture of your setup?
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”