PlasmaCam loss of cut

PlasmaCam Hardware discussion forum
Post Reply
fyrpower
2 Star Member
2 Star Member
Posts: 67
Joined: Wed Aug 12, 2009 2:03 pm

PlasmaCam loss of cut

Post by fyrpower »

I have a PC table, hypertherm 600, This problem just started, when I cut out a design every thing works great then on the last cut outside perimeter . starts out fine then with a 1/4 left the torch does not cut all the way through, like for some reason the ground is lost... any ideas??? does not matter what ga I am cutting, I have had this machine for many years and never had this problem before.
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”