Plasmacam DHC2, hypertherm PM65, Designedge is lastest release with advanced height, advance design and advanced machine control, Air is monitored at ~110psi right at the plasma cutter inlet monitored by pressure gauge, All settings are in accordance with the finecut low speed chart for the PM65 (it does say "not a dross free cut).
I changed to new OEM finecut consumable last night. I seem to be getting a lot more dross on top, especially at pierce, and more dross on back of parts. Is this normal or should i adjust parameters to get a better dross free cut? If pictures are needed I will have to wait til tonight after i get done teaching.
It is currently Sat Dec 16, 2017 9:40 am
PlasmaCam Hardware discussion forum
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest