Help needed hypertherm 1250 wiring
-
- 1 Star Member
- Posts: 13
- Joined: Fri Jul 17, 2009 8:41 pm
Help needed hypertherm 1250 wiring
I have a 1250 with a hand torch right now hooked up to my plasmacam i just bought a machine torch not sure how to wire it to fire with the plasmacam.Any help would be appreciated.
- rdj357
- 4 Star Elite Contributing Member
- Posts: 1168
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
- Contact:
Re: Help needed hypertherm 1250 wiring
You will need to leave the large black and red wires attached where they are currently to provide the correct divided arc voltage.
The trigger circuit is different for the machine torch. You can unhook the small black and white wires from the purple trigger wire that was cut and put the purple wire back together. The small black and white wires need to be connected to the CPC plug at the back of the machine (or the wires going to the plug) on pins 3 and 4. It doesn't matter which goes on which as this is a dry contact for the trigger.
The trigger circuit is different for the machine torch. You can unhook the small black and white wires from the purple trigger wire that was cut and put the purple wire back together. The small black and white wires need to be connected to the CPC plug at the back of the machine (or the wires going to the plug) on pins 3 and 4. It doesn't matter which goes on which as this is a dry contact for the trigger.
Robert Johnson
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC
Plasmacam Goodies! Snap'NCut Mount, AXXON Cards/Cables, Maintenance Items
Learn Plasmacam Workshops
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC
Plasmacam Goodies! Snap'NCut Mount, AXXON Cards/Cables, Maintenance Items
Learn Plasmacam Workshops
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube
-
- 1 Star Member
- Posts: 13
- Joined: Fri Jul 17, 2009 8:41 pm
Re: Help needed hypertherm 1250 wiring
OK thanks for the info that sounds simple do i need to do anything when i use the hand torch other than connect the purple wire back to together.Thanks again for your help.
-
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Help needed hypertherm 1250 wiring
No, Just unplug the machine torch and plug in the hand torch. The hand torch will fire only from its trigger switch. Jim Colt Hypertherm
-
- 1 Star Member
- Posts: 13
- Joined: Fri Jul 17, 2009 8:41 pm
Re: Help needed hypertherm 1250 wiring
Ok thanks Jim.