So i went to turn on my Plasma cutter this morning and have no power. I just used it a few days ago and it worked fine. I have a shut off panel with 2 70amp 250volt time delay blade fuses but no multimeter to check for current. could it be the fuses need replacing. I always leave it in the on position whether im using the cutter or not or could it be something else.
It is currently Mon Jun 18, 2018 5:38 am
Hypertherm Plasma Cutter discussion forum.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests