Powermax 105 Torch in Powermax 45XP
-
- 3 Star Elite Contributing Member
- Posts: 255
- Joined: Wed Apr 29, 2009 8:14 am
- Location: Helotes, TX
Powermax 105 Torch in Powermax 45XP
It's not reasonable to pull out my PM105 and install a PM45XP for daily operation. I only have one torch station on my gantry and switching torches and cables is not easy. However, if the PM105 torch will plug into the PM45XP and I can use it for marking, I'll buy one. What say you Jim Colt?
Victor Simonis
Grey Forest MetalCraft
Helotes, TX 78023
210-872-2622
Sector Technologies Photon 5x10 water table machine with Hypertherm Micro Edge Controller, Powermax 105
Grey Forest MetalCraft
Helotes, TX 78023
210-872-2622
Sector Technologies Photon 5x10 water table machine with Hypertherm Micro Edge Controller, Powermax 105
-
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Powermax 105 Torch in Powermax 45XP
The Powermax105 torch is the same Duramax torch that can be used on the Powermax45 XP, Powermax65, Powermax85. Cut quality and consumable life is the same....based on the power level of each system.
-
- 3 Star Elite Contributing Member
- Posts: 255
- Joined: Wed Apr 29, 2009 8:14 am
- Location: Helotes, TX
Re: Powermax 105 Torch in Powermax 45XP
So I can use my PM105 torch in the PM45XP and get the marking capability I'm looking for?
Victor Simonis
Grey Forest MetalCraft
Helotes, TX 78023
210-872-2622
Sector Technologies Photon 5x10 water table machine with Hypertherm Micro Edge Controller, Powermax 105
Grey Forest MetalCraft
Helotes, TX 78023
210-872-2622
Sector Technologies Photon 5x10 water table machine with Hypertherm Micro Edge Controller, Powermax 105
-
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Powermax 105 Torch in Powermax 45XP
Yes.....it is the same torch, same consumables. Obviously use the cut charts for the 45 XP. The Marking only works on the 45 XP because the Power supply can operate down to 10 amps (the 105 has a minimum of 25 or 30) and the air flow auto corrects when you install the marking nozzle, set the mode switch and amperage. Jim Colt Hypertherm