Ground on cnc port

Post by **Masons Forge** » Tue Feb 14, 2017 10:49 pm

I'm not sure if I'm asking this right but. I have a PM45 with a machine torch. I have it hooked up to a proma THC. I have the start/stop and voltage divider attached. Where should the ground pin go?
Thanks

Post by **jimcolt** » Wed Feb 15, 2017 10:32 am

The ground is if you use a shielded cable and want to ground the shield for noise suppression. 99.9 % of the time it is unused. Jim Colt Hypertherm

Post by **Masons Forge** » Wed Feb 15, 2017 2:50 pm

Thanks Jim

Ground on cnc port

Ground on cnc port

Re: Ground on cnc port

Re: Ground on cnc port