Fund raiser sign

Post by **DJC** » Fri May 11, 2018 2:22 pm

Was asked to make a sign for an upcoming golf scramble to raise money for the schools athletic program. It is based off a file I found here, is that okay to do, using someone else's work??

sponsor plaque.pcm

Post by **DJC** » Fri May 11, 2018 3:03 pm

How do I make it a .dxf so folks can see it??

Specialkfab · Post by **Specialkfab** » Fri May 11, 2018 4:51 pm

From the design edge file on your plasmacam software export it as a dfx file then post here.

Post by **DJC** » Fri May 11, 2018 5:08 pm

try again

sponsor plaque.dxf

Post by **DJC** » Fri May 11, 2018 5:09 pm

Thanks for teaching me how to do that!

Specialkfab · Post by **Specialkfab** » Fri May 11, 2018 5:22 pm

No problem. Where ya located?

Post by **DJC** » Fri May 11, 2018 5:32 pm

Miles City MT
How do I get an image to show up so folks don't have to open it to see it?

Specialkfab · Post by **Specialkfab** » Fri May 11, 2018 5:55 pm

You have to use a program like inkscape which is a free program and convert the dfx to a jpg file.

Specialkfab · Post by **Specialkfab** » Fri May 11, 2018 6:00 pm

Like this.

Post by **DJC** » Mon May 14, 2018 2:46 pm

Let me try a test and see if I did it right...

Post by **DJC** » Mon May 14, 2018 2:47 pm

oops, that wasn't it, will try again

Fund raiser sign

Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign

Re: Fund raiser sign