Another weld jig

[Scratch]

Finally got some time to weld one of these suckers up. I know there are a few different designs of these on here, so I thought I'd throw in the design I like best, maybe someone else will like it. It's super simple and you all can probably draw it up yourself, but I thought I'd share it anyways because sharing is caring right?

I didn't want the holes in it since I figure I'd be clamping it to the table anyways. I did want to be able to fit a vice grip in there... hence the slots. It's 1/4"x4"x12"x12", and the center "web" is in the center of the jig, not flush on the flat edge like some.
Enjoy!
(There are two of the center pieces in the drawing because waste is bad)

2.jpg

3.jpg

Screenshot (23).png

12x12x4square.CDR

12x12x4square.DXF

[plasmanewbie]

Pretty sweet Scratch. Sharing is caring Thank you!

[otisa2007]

nice thankyou

[whiskeymike]

Nice, thanks for sharing. Have you considered using notches or cutting the corner off so you access inside corner for welding?

[Old Iron]

Thanks for sharing.
Unfortunately my Qcad won't let me work with it.

[Rex]

Thanks I can use that

[Jason@bc]

thanks a lot, looks like another useful tool.

[Searchman]

A very useful share. Thanks

[sunnybunny]

Thanks

[shalfpap]

Thanks for sharing!!

[mayper]

Thanks for sharing

[SlagBandit]

Good idea! Thank you !

[mardybum]

Another to drag up from the depths.

Thank you for the share

[RONWB]

thanks

[Thesteelcave]

Thanks looks great!

[jmersereau]

This will come in handy and save me some $$$'s, thanks.

[david jordan]

Thank you.

[Rockdog]

Can not have enough weld jigs. Great idea, Thank you.

[mywifestruck]

Thanks for sharing

[reklez2010]

Great Share. Thank you!

[adbuch]

That's a great design! And a very handy tool to have for quick setups.
David

[oneoffgarage@gmail.com]

Thank you