fixture table

schmaus · Post by **schmaus** » Sun Sep 10, 2017 8:28 pm

I modified the table posted here to fit my needs. I drew it for 1/4" but have not cut it yet so i would test fit the slot and tabs.

fixture top 24x36 1 pc.dxf

fixture support 36 4 pc.dxf

fixture support 24 5 pc.dxf

Proballz03 · Post by **Proballz03** » Sun Sep 10, 2017 10:38 pm

nice thanks for sharing!

Post by **Peechy** » Mon Sep 11, 2017 12:04 pm

Great! Thanks for the share

CypressCreek · Post by **CypressCreek** » Mon Sep 18, 2017 10:23 pm

Looks just like my weld table from WeldTables.com

jasonwhite11 · Post by **jasonwhite11** » Fri Oct 25, 2019 7:11 am

Does this file work when you run it does the fixture table assemble easily?

Thx for posting

J

schmaus · Post by **schmaus** » Sun Oct 27, 2019 5:16 pm

I haven't cut it yet. My table still has my router on it. I haven't finished my downdraft cabinet yet. This file is just a modified one I found on this site.

RedEdge · Post by **RedEdge** » Wed Oct 30, 2019 8:29 am

This file will definitely not be able to be assembled as is. The tolerances just arent there. You need to do a bit of adjusting and testing depending on the true thickness of you materials. Slots need to be widened and deeper. Also being that plasma leaves a noticable taper, the holes on this table will not work 100%. Drop in tools require a tight fit and straight walls so they dont wobble. This file can work if you put a little work to match your material, but dont expect it do be as good as a milled top or even laser.

fixture table

fixture table

Re: fixture table

Re: fixture table

Re: fixture table

Re: fixture table

Re: fixture table

Re: fixture table