Belgian Shepherd

Share, browse, & download dxf, svg, or other vector based designs. If you take be sure to give back.
Post Reply
User avatar
JD770
2 Star Elite Contributing Member
2 Star Elite Contributing Member
Posts: 62
Joined: Wed Jun 23, 2010 3:23 pm
Contact:

Belgian Shepherd

Post by JD770 »

Belgian Shepherd burning and etched into the stainless steel

Image
Image
3.rar

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

User avatar
Larry83301
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 2645
Joined: Tue Oct 27, 2009 6:36 pm
Location: Twin Falls, Idaho

Re: Belgian Shepherd

Post by Larry83301 »

Very nice piece. Thanks for sharing.


Larry
User avatar
Gogogadget62
1 Star Member
1 Star Member
Posts: 17
Joined: Fri Mar 17, 2017 9:49 pm

Re: Belgian Shepherd

Post by Gogogadget62 »

This is a beautiful piece, would you care to share the files in DXF, and tell me how to convert a rar file to dxf , thanks Larry
Dan Gauthier
5x10 Samson
Miller 185 wire feeder
600 Hypertherm
45 Hypertherm
85 Hypertherm
40 ton press and dies
powder coating
80 gallon DeVAIR compressor 5Hp
plasmapros
2.5 Star Member
2.5 Star Member
Posts: 135
Joined: Tue Sep 02, 2008 4:33 pm

Re: Belgian Shepherd

Post by plasmapros »

Dxf is too large at 1.9 Mb (not the cleanest file) so attached is an svg from the rar file which should work for you. Hope this helps :D
3.svg

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

User avatar
Larry83301
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 2645
Joined: Tue Oct 27, 2009 6:36 pm
Location: Twin Falls, Idaho

Re: Belgian Shepherd

Post by Larry83301 »

Gogogadget62 wrote:This is a beautiful piece, would you care to share the files in DXF, and tell me how to convert a rar file to dxf , thanks Larry

All I did was use WinRAR to unrar the file. It's almost 2meg so there is no way it can be posted as a DXF file. If you can not get it unrared any other way just send me a PM with your email address and I'll send you the DXF file. :D

Larry
User avatar
Gogogadget62
1 Star Member
1 Star Member
Posts: 17
Joined: Fri Mar 17, 2017 9:49 pm

Re: Belgian Shepherd

Post by Gogogadget62 »

ok thanks Larry don't have the program but going to look into it thanks for the reply
Dan Gauthier
5x10 Samson
Miller 185 wire feeder
600 Hypertherm
45 Hypertherm
85 Hypertherm
40 ton press and dies
powder coating
80 gallon DeVAIR compressor 5Hp
Post Reply

Return to “DXF & SVG Plasma Cutting File Sharing Forum”