Nesting Help-Trophies

yeomansjon · Post by **yeomansjon** » Wed Jul 01, 2015 5:19 pm

I have to make 35 of these 'trophies' for a big car/bike/truck show in our area. I'd like to be as efficient as possible with this (obviously) and when i try to fit as many as I can on 1 4x4 sheet. I can arrange to fit 10 on 1 piece, leaving me needing 4 sheets, but does anyone out there see that they could use nesting software and find a configuration that will fit 11 or 12 on 1 4'x4' sheet? Any help would be appreciated, thanks![attachment=0]Opp_Works_Trophy_R0_pcm.pcm

YouTube · Post by **rdj357** » Wed Jul 01, 2015 6:19 pm

10 is as good as I can get on a 4x4 using NestMaster.

muzza · Post by **muzza** » Wed Jul 01, 2015 8:24 pm

If you set it out to cut 8x4 and index your sheet this was 5 minutes roughly laying them out to get 22, a bit of messing around and you'll probably get more.
Murray

trophies x 22.jpg

Post by **ou812** » Thu Jul 02, 2015 10:09 am

yeomansjon · Post by **yeomansjon** » Thu Jul 02, 2015 12:40 pm

Thanks Guys, I appreciate it! I can probably index an 8' sheet no problem.

Nesting Help-Trophies

Nesting Help-Trophies

Re: Nesting Help

Re: Nesting Help

Re: Nesting Help-Trophies

Re: Nesting Help-Trophies