Dana 44 Dif Cover

pertneer · Post by **pertneer** » Mon May 25, 2015 7:07 pm

I haven't shared in a while so here is what i have. I made the entire cover, but I did not draw all of it up.

Dana_44_ring.DXF

cbassjr · Post by **cbassjr** » Mon May 25, 2015 7:17 pm

Thanks for the share.

eddieburnsii · Post by **eddieburnsii** » Sat Aug 20, 2016 10:16 pm

Thank your for sharing.

Gamelord · Post by **Gamelord** » Sun Aug 21, 2016 12:09 pm

Nice!!!

HammerDownJustin · Post by **HammerDownJustin** » Sun Aug 21, 2016 3:16 pm

Nice job and thank you. I haft to make a cover for a Ford 8.8 soon so will share it afterwards.

Fordgal · Post by **Fordgal** » Mon Aug 29, 2016 12:13 pm

Awesome. Thanks

gamble · Post by **gamble** » Mon Aug 29, 2016 4:14 pm

Cool. A diff cover is on my list of things to make for another car but I can't for the life of me figure out measurements

Post by **tjenus** » Mon Aug 29, 2016 4:36 pm

gamble wrote:Cool. A diff cover is on my list of things to make for another car but I can't for the life of me figure out measurements

What cover are you looking for?

gamble · Post by **gamble** » Mon Aug 29, 2016 9:05 pm

4g63
I have the flange done but want to make the cover like yours that is 3 pieces all bent. I assuming it's done in solid works?

Post by **richiemirtsching** » Wed Aug 31, 2016 4:16 pm

Does anyone have a truss of a Chevy 44

Klinzmann Fabrication LLC · Wed Aug 08, 2018 11:38 am

Thanks for sharing!

Post by **cetane** » Tue Nov 05, 2019 10:23 am

how tall is the middle of it?