Action points

SheetCam related questions and tips can be posted here
Post Reply
Little Bit
1 Star Member
1 Star Member
Posts: 11
Joined: Thu Jul 17, 2014 7:59 am

Action points

Post by Little Bit »

Hello all
I have been trying to get the action points in sheet cam to cooperate but I just dont seem to understand I lay (3) .5 Flat bar next to one another
and cut across the X axes at 6'' intervals at the seam I want to slow down slightly for .125 and then after the seam speed back up till the next seam but at the first seam it does slow down but it does not speed back up what is the significance of the shaded triangle as a posed to the un shaded triangle ? when i start code THC on or off ? do I need two triangles before the seem and another two after when I try stuff sometimes the triangles act all over the place I dont see any videos to watch Can any one shed some light on this please

Thanks
Little Bit
Post Reply

Return to “SheetCam”